Plunger Wrench

This is a wrench for your plunger. It's smaller and tougher than stock. The skeletonized handle also allows you to loop it onto a keychain or otherwise attach it to your quiver, or tools you keep in your quiver.

The stiffness and durability of the wrench are not intended for over-tightening the plunger onto your bow. Rather, this is a measure to help prevent it from breaking after frequent use. The shorter length of the wrench is meant to both make it more compact and portable, but also to reduce the amount of leverage available and therefore the torque that can be applied to the plunger.

Occasionally, if a threaded item like a plunger button is left installed for a long time, the "stiction" to remove the item again can be greater than the force that was initially used to install it. If the original installation force was close to the limit of the wrench then it may become difficult or impossible to remove the item without breaking the tool. This is the main problem that this wrench is intended to address.

This wrench is made from PLA plastic, which is unlike our other products. PLA is far less heat-resistant but significantly stiffer, which makes it more suitable for this application.